Selecting Midpoints
Contents
From the "Dynamic Reports Selection" dialog, in a "Select Extra Transiting/Progressing/Radix Points" dialog...
>> To switch on a single midpoint
1.Select the first point of the midpoint in the left hand list of points.
2.Select the second point in the right hand list of points.
3.Click on the On button. If the midpoint is not already selected, then this will add the midpoint between those two points to the list of selected midpoints.
>> To switch off a single midpoint
•Click on the midpoint in the list of selected midpoints. This will remove it from the list.
>> To switch on or off a group of midpoints
1.Select any number of points from the left hand list of points. Selecting zero points has the same effect as selecting all the points. Multiple selections may be made by holding down the Ctrl key whilst clicking on points on the list.
2.Similarly select any number of points from the right hand list of points.
3.Click on the On button (or the Off button). This will add (or remove) all of the midpoints formed by combining the two selections. See the example below.
>> To switch on all the midpoints of the Moon to every other chart point
1.Select the Moon in the left hand list
2.Select no points in the right hand list
>> To switch on all the midpoint of the moon to the outer planets
1.Select the Moon in the left hand list
2.Select each of the outer planets in the right hand list
>> To switch on all the midpoint between outer planets
1.Select each of the outer planets in the left hand list
2.Select each of the outer planets in the right hand list
>> To clear all selected of midpoints
•Select the Clear button.
Note: It is possible for you to select up to 595 different midpoints. However, unless you are running a dynamic report covering a very short time span only, it is recommended that you save and use selections of no more than about 50 midpoints at a time, in order to avoid generating a dynamic report which is far too long to be useful.