Aspect Lines
Contents
Aspect line properties in the "Wheel Designer"...
•From & To Circle - These define the circles between which the aspect lines will be drawn. Usually aspect lines are drawn to different points on the same circle. In this case both these should be set to the same circle number.
•From & To Chart - These must be in the range 1 to the number of charts in the current wheel. These define the charts between which the aspect lines will be drawn. Usually aspect lines are drawn to different points in the same chart. In this case both these should be set to the same chart number. If they are set to different chart numbers, then you will see aspects between those two charts.
•From & To Tick Ratio - These must be numbers from 0 to 1. They indicates how long the tick marks are in relation to the distance between the inner and outer circles. Use a value of zero to switch off the tick marks.
•From & To Tick Width - This is the line width used to draw the tick marks at the planetary positions on the circle. Aspects are drawn to the end of these tick marks instead of to the circles, unless the tick ratios are zero.